Dual barbell type adjustment knosb lock the angle of tilt on each of the two display brackets. The brackets mount separately to the display allowing for lift and lock installation. Additionally, certain 32 displays with separate or bottom mounted speakers and with minimal frame bezels may not completely conceal the 30 width of the wall plate. This mount utilizes two safety screws at the bottom of each tv bracket. The safety screws are tightened after the angle of tilt is set to prevent liftoff of your display once mounted.The mount includes written instructions and mounting hardware.
. The hardware package includes display screws in the standard 5mm, 6mm, and 8mm metric sizes. The hardware package also includes spacers to accommodate tvs wiht curved backs, recessed anchor holes, and where the user would like additional separation from the wall. Recently some lower cost displasy have used 4mm metric screws which are not supplied. The wall hardware will support wooden stud installations and also masonry. Large rectangular cable pass through opening ni wall plate. Separate dipslay brackets for lift and lock installation. Printed instructions and all necessary mounting hardware included. Angle of tilt 0-25 degrees. Hole pattern coverage 28 horizontal by 19 vertical. Wall plate mounting slots continuous across top and bottom, 1.3 wide. Wall plate cable management opening 5.2x29.6. Tv arm brackte height 20. If you need to change the address later, charges may apply. International addresses includign canada and mexico. Plaese pay within 48 hours.